NotesRe-Clockable Flange--Y, Nose Cone Material--Aluminum, Mounting Bolt Hole Quantity--2, Mounting Flange to End of Case (MM)--143.5, Nose Cone Type--Closed Nose, Mounting Hardware Included--N, Mounting Flange to Pinion End at Rest (IN)--1.14, Mounting Flange to End of Case (MM)--1, Power Rating (K7)--1, Mounting Shims Included--Y, Width (in) (in)--1, Length (in) (in)--13.88, Mounting Hardware Included--No, Meets or Exceeds Original Equipment Manufacture Specifications--Y, Tooth Quantity--9, Family--PG260D, Nose Cone Type--C, Weight (lb) (lb)--6, Case Grounding--Grounded Case, Solenoid Attached--Y, Over-Crank Protection--N, Voltage--1, Re-Clockable Flange--N, Mounting Flange to Pinion End at Rest (MM)--29, Mounting Type--F, Design--Permanent Magnet Planetary Gear Reduction, Mounting Flange to Pinion End at Rest (IN)--1, Mounting Shims Included--No, Height (in) (in)--10.25, Mounting Flange to End of Case (IN)--5.65, Mounting Flange to End of Case (IN)--5, Meets or Exceeds Original Equipment Manufacture Specifications--Yes, Voltage (2H)--1, Mounting Type--Flange, Starter Rotation--C, Power Rating (HJ)--1, Mounting Flange to Pinion End at Rest (MM)--2, Nose Cone Material--A, Programming Required--N
Sub TypeStarter Motor