Sensores de movimiento PIR

This feature can be achieved (sensor output and blockade times) the interval between work, can be applied to interval detection products; at the same time this function can inhibit various disturbances load in the process of switching.

Umfassender Service. Schaltausgang: High/Low Level Signal: 3.3V TTL. Art.Nr: SE10003. Marke: Eckstein Komponente. Sensorlinse size: (diameter): 23mm (default). Arbeitstemperatur: -15- 70°C. rechts drehen, Entfernung erhöhen (bis 7m).

(Beispielfoto). Siemens Bewegungsmelder Aufsatz. DELTA I-SYSTEM BEW.MELDER-AUFSATZ 2.2 KOMFORT ALUMINIUMMETALLIC, 55X55MM. Als Gewerbekunde, Selbständiger oder Freiberufler profitieren Sie ebenso wie Behörden und Verbände.

(Beispielfoto). Pepperl&Fuchs Radar - Bewegungsmelder. Gewerbetreibende und nicht an Verbraucher. Haben Sie etwas zu verkaufen?. Als Gewerbekunde, Selbständiger oder Freiberufler profitieren Sie ebenso wie Behörden und Verbände.

DECKEN-AUFPUTZ PIR-BEWEGUNGSMELDER SCHALTET LAMPEN, LED, HALOGEN & NEON ! Dieser Bewegungsmelder schaltet durch seine 3PIR-Technologie sehr genau bei Eintreten in das Wahrnehmungsfeld, sicher, automatisch, benutzerfreundlich und energiesparend Beleuchtung wie Glühbirnen, Energiesparlampen und auch LEDs.

Using pyroelectric PIR sensor, Fresnel. Non-repeatable trigger L trigger / H Repeat Trigger. Easy to use, power - signal output. 110 ° angle sensor. Low-power, static power 65uA. Repeatable / not repeatable trigger mode selection.

RGBZONE Aotomatic Mini 5A PIR Infrared Motion Sensor Detector Switch for LED NEW Operating voltage: DC 5V-24V Load current ：4A Delay time: Default setting 3-15sec(2~360 Seconds is adjustable) Detecting range：110 degrees cone angle Automatic Induction: When people enter into the range of induction, it will output a voltage equal to input voltage, after the delay time, it will output 0V during the delay time if motion detected, the delay time will reset, and start a new delay time Trigger Way: Continuous triggering,Light Sensor: 10LUX VIPMOON Aotomatic Mini 5A PIR Infrared Motion Sensor Detector Switch for LED Strip Light Female Male DC Power Connector Specifications : Operating voltage: DC 5~24VLoad current：4A Static power loss :≤50 uALight sensitivit.

1 x DC 12V-24V 8A Automatic Infrared PIR Motion Sensor Switch. Applications: Incandescent lamp, energy-saving lamps, LED lamp, fluorescent lamp and other kinds of loads. Output power ?. 12V: <96W, 24V: <192 W.

Induktiver Ringsensor. Auflösung 1,0 mm (stahlkugel).

Ringdurchmesser 15,1 mm. Induktiver Ringsensor. Auflösung 2,0 mm (stahlkugel).

If you are not happy with the charge the sale can be cancelled. During that process you will be issued with an RMA number.

Incandescent lamp, energy-saving lamps, LED lamp,control LED light lamps and LED Strips. You can conveniently to let the light auto on/off. The switch can detect human body's infrared, and use infrared to control the load.

Repeatable trigger: the sensor output high, the delay period, if there is human activity in its sensing range, the output will remain high until people leave after the high variable delay lOW (automatically extended sensor module detects the human body after every activity a delay period, and the last time an event is the starting point of the delay time).

Also suitable for use with conventional or 'wax-stat' driven shutter fans.

If you are not happy with the charge the sale can be cancelled. During that process you will be issued with an RMA number.

KANLUX BLACK OUTDOOR IP44 PIR SENSOR. 160 DEGREE FLEXIBILITY - 230V.

The product adopts good sensitivity detector and integrated circuit. It gathers automatism, convenience, safety, saving-energy and practical functions. It utilizes the infrared energy from human as control-signal source and it can start the load at once when one enters detection field.

The product adopts good sensitivity detector and integrated circuit. It gathers automatism, convenience, safety, saving-energy and practical functions. It utilizes the infrared energy from human as control-signal source and it can start the load at once when one enters detection field.

1PCS Mini IR Pyroelectric Infrared PIR Motion Human Body Sensor Module. b, repeatable trigger: the sensor output high after the delay period, if the human body in its sensing range activities, its output will remain high until after the delay will be left high to low (sensor module review Measured activities of each body will be automatically extended after a delay time, and the final event of the delay time Starting point of time).

The product is a new saving-energy product; it adopts microwave sensor mould with high-frequency electro-magnetic wave (5.8GHz), integrated circuit. It gathers automatism, convenience, safety, saving-energy and practicality functions.

The product is a new saving-energy product; it adopts microwave sensor mould with high-frequency electro-magnetic wave (5.8GHz), integrated circuit. It gathers automatism, convenience, safety, saving-energy and practicality functions.

The product is a new saving-energy product; it adopts microwave sensor mould with high-frequency electro-magnetic wave (5.8GHz), integrated circuit. It gathers automatism, convenience, safety, saving-energy and practicality functions.

Die Teile bzw. Geräte wurden aus funktionierenden Produktionsanlagen demontiert, oder. Wetterfest / 15 Meter.

We want you to feel confident that you are purchasing the right product from the right Electronic Component supplier. Here are just a few of the reasons why we think you will be delighted with our service.

This is a sophisticated passive infrared sensor module that does the "heavy lifting" of detecting motion, filtering, etc, for you. The on-board BIS001 IC chip handles all of the signal processing and outputs a digital high signal when motion is detected.

Nice Photocell M pack of 2 New unused. Bought these with an electric gate setup and didn’t need them in the end. Sensors to stop gates if car or person breaks line between them.

Good replacement for falling through or faulty doppler radar microwave motion sensor module. 1x Doppler motion sensor ( one piece ). Security alarm and sensor. Light sensor. High resistant to radio-frequency disturbance.

It has a high value of 3.3 volts and a low of 0 (it is either on or off). It's delay time can be adjusted from 5 to 200seconds as well as the sensing range from 3meter to 7meters. The entire sensor with the board is 32mm by 24mm (standard pir motion sensor).

Die Typennummer lautet ISG-A24-240/24VDC 8IG 024 246. Zum Verkauf steht ein Pantron IR-Amplifier. creative automation systems.

The PIR Sensor requires a "warm-up time" in order to function properly, about 10s to1min,depend on the delay time during this time, the signal triggered by the module is not stable, after one minute, it will be ready.